Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE Guida di Installazione Scaricare il pdf (Pagina 40)

software to the wrong system. This option verifies only the HP SIM server's certificate

name submitted.

NOTE: HP strongly recommends using the Trust by Certificate option because the

other options are less secure.

The server name option must meet the following criteria:

— Each server's certificate name must be less than 64 characters.

— The overall length of the server's certificate name list is 1,024 characters.

— Special characters must not be included as part of the server's certificate

name: ~ ' ! @ # $ % ^ & * ( ) + = \ ": ' < > ? , | .

— Semicolons are used to separate server's certificate names.

To trust by name:

1. Select Trust by Name, and click Next.

2. In the Trusted Server Name field, enter the HP SIM server's certificate name to

be trusted.

3. Click Add. The trusted HP SIM server's certificate name appears under the Trusted

Servers list. You can click Save to save your changes up to this point or click

Cancel to discard the changes and close the wizard.

4. Click Next. The IP Binding page appears.

• Trust All Sets the HP System Management Homepage to accept certain configuration

changes from any system.

NOTE: HP strongly recommends using the Trust by Certificate option because the

other options are less secure.

To trust all servers:

1. Select Trust All. You can click Save to save your changes up to this point or click

Cancel to discard the changes and close the wizard.

2. Click Next. The IP Binding page appears.

9. IP Binding specifies from which IP addresses the HP System Management Homepage accepts

requests and provides control over which nets and subnets requests are processed.

Administrators can configure the HP System Management Homepage to only bind to

addresses specified in the IP Binding page. A maximum of five subnet IP addresses and

netmasks can be defined.

An IP address on the server is bound if it matches one of the entered IP Binding addresses

after the mask is applied.

NOTE: The HP System Management Homepage always binds to 127.0.0.1. If IP Binding

is enabled and no subnet/mask pairs are configured, then the HP System Management

Homepage is only available to 127.0.0.1. If IP Binding is not enabled, you bind to all addresses.

To configure IP Binding:

1. Select IP Binding. The IP Binding page appears.

2. Enter the IP address.

3. Enter the netmask.

4. Click Add. The IP binding configuration is saved and appears under the IP Binding

List.

5. Click Next. The IP Restricted Login page appears.

40 Installing HP SMH using the HP Smart-Update Manager (HPSUM)

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

Commenti su questo manuale

Nessun commento

Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE Guida di Installazione Pagina 40

Commenti su questo manuale

Prodotti e manuali riguardandi Software per gestione di rete Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE