Red Hat LINUX VIRTUAL SERVER 4.5 - ADMINISTRATION Guida di Installazione Scaricare il pdf (Pagina 123)

Choosing and Installing Guest Operating Systems

123

4. When prompted, choose IDE CD-ROM.

5. Create a new boot partition. The guest operating system reboots. The

installation continues.

6. VMware ESX Server: Jump to step 7.

VMware Workstation and VMware GSX Server: To configure IP networking,

do one of the following:

• If you chose bridged networking for the virtual machine, enter its IP address.

When NetWare tries to load the LAN driver (using pcntnw.lan), it fails

because it broadcasts for its own IP address. This causes IP networking to fail.

To work around this, open the System Console (press Ctrl-Esc) and type

set allow ip address duplicates=on

Press Alt-Esc to return to the installation.

• If you chose host-only networking for the virtual machine, look up the host

machine's IP address.

At a command prompt on a Windows host, type

ipconfig /all

At a command prompt on a Linux host, type

ifconfig

Note the host’s IP address for VMnet1 and change the last octet so it is greater

than the last octet in the IP address of the host.

For example, if the host IP address is 192.168.160.1, then the virtual machine’s

IP address is 192.168.160.###, where ### is any number greater than 1 and less

than 128.

For the subnet mask, enter 255.255.255.0.

For the router gateway, enter the host’s IP address (192.168.160.1 in our

example).

• If you chose network address translation (NAT) for the virtual machine, look up

the host machine's IP address.

At a command prompt on a Windows host, type

ipconfig /all

At a command prompt on a Linux host, type

ifconfig

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 147 148

Nessun commento

Red Hat LINUX VIRTUAL SERVER 4.5 - ADMINISTRATION Guida di Installazione Pagina 123