Red Hat ENTERPRISE LINUX 4.5.0 - Guida Utente Scaricare il pdf (Pagina 24)

packets per monitoring cycle. Specify 0 when you want a report as soon as the error is detected.

When the network cable is pulled out or HUB power switch is off, a Network Hardware error occurs.

Each error occurs for the following reasons.

Error

Reason

Alignment Errors

Broken packets for collision

FCS Errors

Broken packets for collision

Carrier Sense Errors

Cable disconnected, Cable defect, or Transceiver defect

Range is 0 to 100 percent. Default value is 50 percent.

Transmission Retry (%)

Specify the threshold of the percentage of collision and delay packets in total transmission packets per

monitoring cycle. Transmission Retry will occur when the server is under the high network load. Range is

10 to 50 percent. Default value is 35 percent.

Transmission Abort (%)

Specify the threshold of the percentage of packets disposed due to excess collisions errors, etc., in total

transmission packets per monitoring cycle. Transmission Abort will occur when the server is under the

high network load. Range is 10 to 50 percent. Default value is 35 percent.

[ok]

Settings are saved and this screen closes.

[cancel]

This screen closes without saving changes.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 116 117

Nessun commento

Red Hat ENTERPRISE LINUX 4.5.0 - Guida Utente Pagina 24