Red Hat ENTERPRISE LINUX AS 2.1 - Guida di Installazione Scaricare il pdf (Pagina 15)

Chapter 1. Steps to Get You Started 7

• NETTYPE=<type>

Where <type> must be one of the following: ctc, iucv, lcs, or qeth.

• IPADDR=<IP>

Where <IP> is the IP address of the new Linux guest.

• NETWORK=<network>

Where <network> is the address of your network.

• NETMASK=<netmask>

Where <netmask> is the netmask.

• BROADCAST=<broadcast>

Where <broadcast> is the broadcast address.

• GATEWAY=<gw>

Where <gw> is either the gateway-IP for your eth device or the IP address of the ctc/escon/iucv

point-to-point partner.

• MTU=<mtu>

Where <mtu> is the Maximum Transmission Unit (MTU) for this connection.

• DNS=<server1>:<server2>:...:<serverN>

Where <server1>:<server2>:...:<serverN> is a list of DNS servers, separated by

colons. For example:

DNS=10.0.0.1:10.0.0.2

• SEARCHDNS=<domain1>:<domain2>:...:<domainN>

Where <domain1>:<domain2>:...:<domainN> is a list of the search domains, separated by

colons. For example:

SEARCHDNS=example.com:example.org

• PORTNAME=<osa_portname> | <lcs_portnumber>

This variable supports OSA devices operating in qdio mode or non-qdio mode.

When using qdio mode: <qeth_portname> is the portname speciﬁed on the OSA device when

operating in qeth mode. PORTNAME is only required for z/VM 4.3 or older without APARs

VM63308 and PQ73878.

When using non-qdio mode: <lcs_portnumber> is used to pass the relative port number as

integer in the range of 0 through 15.

• FCP_<n>="<device_number> <SCSI_ID> <WWPN> <SCSI_LUN> <FCP_LUN>"

The variables can be used on systems with FCP devices to preconﬁgure the FCP setup and can be

subsequently edited in anaconda during the installation. An example value may look similar to:

FCP_1="0.0.5000 0x01 0x5105074308c212e9 0x0 4010"

• <n> is an integer value (e.g. FCP_1, FCP_2, ...).

• <device_number> is used to specify the address of the FCP device ( 0.0.5000 for device

5000, for example).

• <SCSI_ID> is speciﬁed in hex-value, typically sequential values (e.g. 0x01, 0x02 ... ) are

used over multiple FCP_ variables.

• <WWPN> is the world wide port name used for routing (often in conjunction with multipathing)

and is as a 16-digit hex value (e.g. 0x5105074308c212e9).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 85 86

Nessun commento

Red Hat ENTERPRISE LINUX AS 2.1 - Guida di Installazione Pagina 15