
Chapter 4. Installing and configuring z/VM 35
4.1.3 Copying a vanilla z/VM system to DASD
This section describes the steps to copy z/VM to DASD.
Perform the following steps:
1. You can now get out of Single Object Operations mode (if you are in it). To do so, log off
the primary SE window by closing that window.
2. Move to the Integrated 3270 Console window (you can use the Alt-Tab sequence). The
RAMdisk should IPL and you should see z/VM boot as shown in Figure 4-8. If the
Integrated 3270 Console window is still blank, be patient, it may take a minute or two to
initialize.
Figure 4-8 z/VM first boot on the Integrated console
Note: The Esc key in the upper left clears the Integrated 3270 console on the HMC.
Commenti su questo manuale