Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Manuale di Installazione Scaricare il pdf (Pagina 59)

Chapter 4. Installing and configuring z/VM 39

6. Move back to the Integrated 3270 Console window. You should see the Standalone

Program Loader panel as shown in Figure 4-12.

Figure 4-12 Stand Alone Program Loader

a. Press the Tab key to get to the IPL Parameters section and enter the value cons=sysg.

This specifies to use the Integrated 3270 console.

b. Press the F10 key to continue the IPL of your z/VM system. This should take around

1 - 3 minutes.

7. At the Start (Warm|Force|COLD|CLEAN) prompt, enter:

==> cold drain noautolog

8. At the Change TOD clock prompt, enter:

==> no

9. The last message should be HCPCRC8082I EREP records are accumulating for userID

EREP. Disconnect from the OPERATOR user ID using the disconnect command:

==> disc

Press Enter to get a new logon window.

4.1.5 Completing the z/VM installation

Perform the following steps to complete the z/VM installation:

1. On the HMC z/VM login window, log on as MAINT. The password is MAINT. You may

receive messages HCPLNM102E or HCPLNM101E about disks not linked or attached. This is

not a problem. Press Enter when you see the VM Read prompt in the lower right corner.

Important: When logging onto a z/VM user ID that runs CMS, you should usually press

Enter at the VM READ prompt. Doing so will run the PROFILE EXEC and result in a

prompt of the form:

Ready; T=0.01/0.01 11:14:20

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 295 296

Nessun commento

Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Manuale di Installazione Pagina 59