Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Manuale di Installazione Scaricare il pdf (Pagina 61)

Chapter 4. Installing and configuring z/VM 41

Congratulations! You should now have a vanilla z/VM system installed.

4.2 Configuring TCP/IP

It is recommended that you initially configure TCP/IP using the IPWIZARD command, which

is generally used just once. After IPWIZARD creates the initial configuration files, they are

typically maintained manually.

From the HMC z/VM logon panel, logon to MAINT. The default password for all z/VM user IDs

is the same as the user ID. So enter a password of maint, which will not be echoed on the

window.

USERID ==> maint

PASSWORD ==>

After entering the user ID and password, press Enter when the status area in the lower right

reads VM READ.

4.2.1 Using the IPWIZARD tool

The IPWIZARD command is on the MAINT 193 disk. You need to access it with file mode G

using the ACCESS command so you will pick up IPWIZARD from that minidisk.

Perform the following steps:

1. Access the MAINT 193 disk:

==> acc 193 g

2. Invoke IPWIZARD:

==> ipwizard

3. The z/VM TCP/IP Configuration Wizard opens, as shown in Figure 4-13. The first field,

User ID, should always be TCPIP. Obtain the remaining values from 2.7.1, “z/VM resources

worksheet” on page 16 and press F8.

Figure 4-13 IPWIZARD panel 1

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 295 296

Nessun commento

Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Manuale di Installazione Pagina 61