Red Hat ENTERPRISE LINUX WS 2.1 - Guida di Installazione Scaricare il pdf (Pagina 12)

12 Introduction

DONE

INDEX

that Bruker cannot support the use of above-named systems. For detailed informa-

tion please look up the software support matrix, provided in pdf-format, on the

Bruker Web server under following address:

http://www.bruker-biospin.com/documentation_general.html

1.4.2 Special PC Hardware requirements

To run TOPSPIN 2.1 with Linux Bruker recommend the following computer hard-

ware:

•PC

with CPU Clock ≥ 1 GHz

•Memory ≥ 512 MB

• Video (graphics)-card memory: 64 MB

• 2 Ethernet cards (the second card is only required if your PC controls a spec-

trometer)

• DVD device

• 3 button mouse or wheel mouse

If your hardware does not meet these requirements, T

OPSPIN might still run but

with a much lower performance.

Furthermore, display resolution must be set to 1280*1024 or higher.

The Installation was tested on a ’HP workstation xw4400’ PC with a ’NVIDIA

Quadro FX560’ graphics card (128 MB) and two ’Broadcom 5751 NetXtreme

Gigabit PCI4 Ethernet’ cards.

1.4.3 Spectrometer requirements

TOPSPIN 2.1 is released for datastations, AVANCE, AVANCE II

and AVANCE III

spectrometers. If you are in doubt which kind of spectrometer do you have please

refer to chapter 12.3 on page 172.

For upgrade possibilities of your spectrometer with T

OPSPIN 2.1, please check with

your local Bruker BioSpin office.

1. TOPSPIN only runs on x86-based PC’s. It does not support 64bit architecture.

2. It is recommend not to use shared memory graphics, because in some cases memory problems

have been observed.

3. TOPSPIN is delivered on DVD’s with “-R” format.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 271 272

Nessun commento

Red Hat ENTERPRISE LINUX WS 2.1 - Guida di Installazione Pagina 12