Red Hat SYSTEM 8.0 - MIGRATION GUIDE 7.X TO 8.0 Guida di Installazione Scaricare il pdf (Pagina 28)

Upgrade Instructions: Web Security Gateway

28  Websense Web Security Gateway Anywhere

c. After upgrade, restart the firewall. In the firewall, be sure to open the ports

used by Content Gateway on this machine. See Websense TRITON

Enterprise default ports for more information.

4. Download the Content Gateway version 7.8.x installer from mywebsense.com

and save it to a temporary directory. For example, place it in:

/tmp/wcg_v78

5. Unpack the Content Gateway installer tar archive:

cd /tmp/wcg_v78

tar -xvzf <installer tar archive>

6. If you intend to upgrade Red Hat Enterprise Linux 6.x to a more recent version,

perform the upgrade now. See your Red Hat Enterprise Linux documentation.

7. In the directory where you unpacked the tar archive (for example, /tmp/wcg_78),

start the installation/upgrade script.

./wcg_install.sh

Respond to the prompts.

Content Gateway is installed and runs as root.

8. If your server does not meet the minimum hardware requirements or is missing

required operating system packages, you will receive error or warning messages.

For example:

Error: Websense Content Gateway v7.8.x on x86_64 requires

several packages that are not present on your system.

Please install the following packages: <list of packages>

If you are connected to a yum repository you can install

these packages with the following command:

yum install <list of packages>

See the Websense Technical Library (www.websense.com/

library) for information about the software requirements

for x86_64 installation.

You may run into this error because 32-bit packages were required for v7.7.x and

64-bit libraries are required for v7.8.x.

Important

If SELinux is enabled, set it to permissive, or disable it

before installing Content Gateway. Do not install or run

Content Gateway with SELinux enabled.

Note

Up to the point that you are prompted to confirm your

intent to upgrade, you can quit the installer by pressing

CTRL+C. If you change your mind after you choose to

continue, do not use CTRL+C to stop the process. Instead,

allow the installation to complete and then uninstall.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Nessun commento

Red Hat SYSTEM 8.0 - MIGRATION GUIDE 7.X TO 8.0 Guida di Installazione Pagina 28