
Upgrade Instructions 33
Upgrade Instructions: Web Security Gateway
7. In the directory where you downloaded the WebsenseCG78Setup_Lnx.tar.gz tar
archive, begin the installation, and respond to the prompts to configure the
application.
./wcg_install.sh
The installer installs Content Gateway in /opt/WCG. It is installed as root.
8. If your system does not meet the minimum recommended requirements, you
receive a warning. For example:
Warning: Websense Content Gateway requires at least 4
gigabytes of RAM.
Do you wish to continue [y/n]?
Enter n to end the installation, and return to the system prompt.
Enter y to continue the installation. If you choose to run Content Gateway after
receiving this warning, performance may be affected.
9. Read the subscription agreement. At the prompt, enter y to continue installation or
n to cancel installation.
Do you accept the above agreement [y/n]? y
10. Enter and confirm a password for the Content Gateway Manager administrator
account:
Enter the administrator password for the Websense Content
Gateway management interface.
Username: admin
Password:> (note: cursor will not move as you type)
Confirm password:>
This account enables you to log on to the management interface for Content
Gateway, known as Content Gateway Manager. The default username is admin.
Note
Up to the configuration summary, you can quit the installer
by pressing CTRL-C. If you choose to continue the
installation past the configuration summary and you want
to quit, do not use CTRL-C. Instead, allow the installation
to complete and then uninstall it.
If you want to change your answer to any of the installer
prompts, you will be given a chance to start over at the first
prompt once you reach the configuration summary; you do
not have to quit the installer.
Commenti su questo manuale