Red Hat SYSTEM 8.0 - MIGRATION GUIDE 7.X TO 8.0 Guida di Installazione Scaricare il pdf (Pagina 34)

Upgrade Instructions: Web Security Gateway

34  Websense Web Security Gateway Anywhere

To create a strong password (recommended), use 8 or more characters, with at

least 1 each of the following: capital letter, lower case letter, number, special

character.

11. Enter an email address where Content Gateway can send alarm messages:

Websense Content Gateway requires an email address for

alarm notification.

Enter an email address using @ notation: [] >

Be sure to use @ notation (for example, [email protected]). Do not enter more

than 64 characters for this address.

12. Enter the IP address for Policy Server:

Enter the Policy Server IP address (leave blank if

integrating with Data Security only): [] >

Use dot notation (i.e., xxx.xxx.xxx.xxx). The address must be IPv4.

13. Enter the IP address for Filtering Service:

Enter the Filtering Service IP address: [<Policy Server

address>] >

The default is the same address as Policy Server.

14. Review default Content Gateway ports:

Websense Content Gateway uses 11 ports on your server:

----------------------------------------------

'1' Websense Content Gateway Proxy Port 8080

'2' Web Interface port 8081

'3' Auto config port 8083

Important

The password length must be 16 characters or less. Also, it

cannot contain the following characters:

 space

 $ (dollar symbol)

 : (colon)

 ‘ (backtick; typically shares a key with tilde, ~)

 \ (backslash)

 “ (double-quote)

Note

As you type a password, it may seem that nothing is

happening—the cursor will not move nor will masked

characters be shown—but the characters are being

accepted. After typing a password, press Enter. Then

repeat to confirm it.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Nessun commento

Red Hat SYSTEM 8.0 - MIGRATION GUIDE 7.X TO 8.0 Guida di Installazione Pagina 34